Monday, August 31, 2015

Reconditioning from Quadriceps Atrophy with KAATSU

Many athletes significantly atrophy due to injuries sustained in practice and gains. In order to quickly and effectively recondition with KAATSU from atrophy of the quadriceps, KAATSU recommendations are as follows using either the KAATSU Master or KAATSU Nano together with the KAATSU Air Bands (both arm and leg bands):

Preparation
*Be well-hydrated before starting KAATSU
*Always follow KAATSU protocols (i.e., always have good capillary refill within 2 – 3 seconds, no occlusion, no numbness)
*Always start with the KAATSU Cycle (i.e., 8 cycles of 20 seconds pressure on + 5 seconds pressure off)

Key Points
*KAATSU can be done daily, even twice per day during rehabilitation or recovery from injuries
*Use a high Base SKU and the highest Optimal SKU that is safe and falls within the standard KAATSU guidelines
*Always begin with at least 2-3 KAATSU Cycles on arms and legs
*Do not release the air in the KAATSU Air Bands throughout the entire reconditioning workout (unless, of course, you feel numbness or become lightheaded)
*Never have pain in the joint, tendon or bone while doing KAATSU
*Always sue the correct form in any movements
*The rest between sets and between exercises should be no more than 20 seconds maximum

Protocols
STEP 1: Start with the KAATSU Cycle on the arms at an average Base SKU and average Optimal SKU (e.g., if your Optimal SKU is 250 SKU, start with an SKU of 220-230). Do 1 – 2 more KAATSU Cycles on the arms as a warm-up.

STEP 2: Set the appropriate Base SKU and Optimal SKU on the arms and do either the KAATSU 3-point Exercises for the arms* or a specific upper body workout with the KAATSU Arm Bands on. If the KAATSU 3-point Exercises are done, do 3 sets each of (1) hand clenches (optionally with hand grips), (2) bicep curls (optionally with light resistance), and (3) triceps extensions (optimally with light resistance) until muscular failure.

STEP 3: Remove KAATSU Arm Bands and place KAATSU Leg Bands on to begin the KAATSU Cycle on the legs.

STEP 4: Do one normal KAATSU Cycle (i.e., 8 cycles of 20 seconds pressure on + 5 seconds pressure off).

STEP 5: Do 3 – 5 modified KAATSU Cycles of 60 seconds pressure on + 20 seconds pressure off at the highest Base SKU and Optimal SKU as possible.

STEP 6: Do the KAATSU 3-point Exercises for the legs or 3 sets of (a) heel raises, (b) standing hamstring curls, and (c) non-lock partial extension squats (both one-leg and two-leg if possible), and walking or other recommended movements as recommended by the physical therapist.

Reminders
*If you can do over 40 repetitions before reaching failure, then the Base SKU and Optimal SKU are too low. Increase the Base SKU or Optimal SKU so ideally the number of repetitions on the first set is 30 repetitions before failure.
*Always breathe throughout the KAATSU exercises and remain well-hydrated.
*Always go to muscle failure on each set. On the last set of each exercise, muscular failure should come quickly.
*A disturbance of homeostasis will occur and muscular discomfort will be significant, partly due to lactate build-up.
*KAATSU Aqua Bands can be used in a therapy pool or swimming pool to augment the recovery if aqua-therapy is also incorporated in the athlete’s rehabilitation program.
*Because KAATSU has systemic effects, it is recommended to also do KAATSU on the arms in addition to the legs.

Copyright © 2015 by KAATSU Global

No comments:

Post a Comment